A passenger jet taking off from Gatwick Airport was involved in a near miss with a preceding aircraft, according to an official investigation.
The UK Airprox Board (UKAB) investigated the incident on April 25 which involved two Airbus 319s.
It said the second plane was cleared to climb which brought it "into conflict" with the first.
When the air traffic controller responsible for the flight realised what was happening he “issued avoiding action to the pilot”, the report stated.
The UKAB found that the near miss was caused by the air traffic controller not scanning his radar display before clearing the second pilot to climb.
“He should have seen (the first aircraft) ahead,” the report added.
A “standard procedure” of reducing the usual separation time between departing aircraft to increase frequency - from two minutes to 45 seconds - was given as a contributory factor.
The UKAB added that “poor co-ordination” by air traffic control staff also had an impact.
Separation between the aircraft was reduced to 700ft vertically and around two miles horizontally.
The report found that “safety had been degraded” but the “rate of catch-up between the two aircraft was very low”.
The incident was assessed as having the third most serious degree of risk by the UKAB.
On July 8, Tecnam participated in the official inauguration of new terminal at Rome Urbe Airport, an event hosted by Italian Civil Aviation Authority (ENAC) and ENAC Servizi to present the f...
Federal Aviation Administration has closed the G-1 Issue Paper, formally establishing the certification basis for Electra’s EL9 Ultra Short aircraft and advancing the company toward the next big...
Embraer will once again have a strong presence at the Farnborough International Airshow in the United Kingdom, highlighting its continued growth momentum driven by increasing aircraft deliveries,...
Embraer announced Phenom 300EV, the latest evolution of the world’s best-selling light jet for 14 consecutive years. The aircraft is now updated with intuitive safety technology, including...