Airbus to equip A350 XWB pylon with bracket
Airbus completed for the first time the installation of a titanium 3D-printed bracket on an in-series production A350 XWB. The bracket, built using additive-layer manufacturing (ALM) technologies (also known as 3D-printing), is part of the aircraft pylon, the junction section between wings and engines.
Additive-layer manufacturing “grows” products from a fine base material powder – such as aluminium, titanium, stainless steel and plastics – by adding thin layers of material in incremental stages, which enables complex components to be produced directly from computer-aided design (CAD) information.
3D-printed parts are already flying on some of Airbus A320neo and A350 XWB test aircraft. These include metal printed cabin brackets and bleed pipes.
3D printed bracket installed on A350 XWB pylon
Lilium is debuting the Lilium Jet, the world's first fully electric jet that can take off and land vertically, to the U.S. market. Lilium Jet is designed and optimized for regional travel with an...
Elbe Flugzeugwerke GmbH, a joint venture of ST Engineering and Airbus, is re-entering the maintenance, repair and overhaul (MRO) market for the world’s largest passenger aircraft, the Airbus A38...
As the sun rises over the expansive Outback and the rugged hills of Middle Earth, one may spot the Bell 505 taking to the skies, its rotor blades slicing through the dawn with precision and grace, acc...
Gogo and Satcom Direct announced entry into a definitive agreement under which Gogo will acquire Satcom Direct to create the only in-flight connectivity provider able to satisfy the performance and co...
